Warranty: Fits to a Tee

LIMITED LIFETIME WARRANTY
Products that have been registered with I Get It, LLC are covered under a limited lifetime warranty.  I Get It, LLC will repair or replace the product at our discretion without cost to the purchaser, for any failures of this product resulting from defects in material or workmanship.
This warranty is not applicable and is void if the product failure is a result of improper assembly, misuse, abuse by overloading, alteration in any way or damage due to accident.  This warranty is not transferable, does not cover chipping, fading, scratches, rust, dents or other damages to the surface due to normal wear and use.  I Get It, LLC is not responsible for consequential, incidental, or other damages or losses resulting from product failure. This warranty is in lieu of all other expressed warranties. In the US, some states do not allow the exclusion or limitation of incidental or consequential damages, so the limitation may not apply to you.  This warranty gives the initial registered owner specific legal rights and those rights extend from state to state, which vary.
 

CARE AND MAINTENANCE
This product was designed and built with the highest standards of quality and its design was targeted for easy user maintenance. The product should be cleaned with a mild detergent soap and water. Rinse clean and towel dry. Do not stand on, sit on or store anything of excessive weight onto the unit. Keep product away from all open flames.

 

WARNING!
As with all training devices, care should be taken when using this product. The "Fits To A Tee"  training product was designed for non divot golf swing practice and therefore should ONLY be used with the driver.  The unit was not designed to take direct driver swing impacts. In addition, additional care must be practiced when using the insertion/extraction tool. The insertion/extraction tool should only be used to created a bore hole in natural earth for insertion and for unit removal as instructed. When not in use, the  insertion/extraction tool should be placed in the carrying bag and kept away from the training area to avoid any incidental or accidental contact with the tool.